Sony CMT-J3MD - Manual (Page 50)

50
Combining recorded
tracks
— Combine Function
You can use this function to combine 2 tracks into
a single track. The total number of tracks
decreases by one and all tracks following the
combined ones are renumbered.
You can also use this function to erase
unnecessary track numbers.
E.g.: Combining track 3 to track 1.
1 2
1 2
4 3
3
E.g.: Combining track 1 to track 4.
1 2
1 2
4 3
3 4
5
Original
tracks
After
COMBINE
A B C D
B C D A
Track
number
Original
tracks
After
COMBINE
A C B D
A B C D
Dividing recorded tracks
(continued)
Andante Adagio Allegro
Andante Adagio Allegro
4
Press . or > repeatedly until the
desired track number to divide appears,
then press ENTER/YES.
“—Rehearsal—” appears and the portion to
be divided is played repeatedly.
5
While monitoring the sound, press .
or > repeatedly to adjust the point to
be divided.
You can shift the point by 1/86 second
(1 frame) intervals.
To shift the point by second or minute
intervals, press m or M so that “s” or
“m” flashes, then press . or >.
6
Press ENTER/YES.
“Complete !!” appears for a few seconds and
the newly created track starts playing.
To cancel dividing
Press MENU/NO.
To return to the condition before
DIVIDE
You can return to the original condition
immediately after dividing the tracks (see page
52). You can also return to the original condition
by using the Combine Function on this page.
Notes
• If you divide a labelled track (page 43) into two
tracks, only the first track retains the track title.
E.g.:
1 2
1 2
4 3
3 4 5
The new track is not labelled
• “Impossible” appears, when you specify the
division point at the beginning or end of a track.
Press . or > to shift the position.