Sharp PG-D3510X - Manual (Page 58)

54
Setting Up the Projector Network Environment (“Network” Menu)
Menu operation n Page 40
SCR SIG PRJ1 PRJ2
SEL./ADJ. ENTER END
Pict. Network
Password Disable
DHCP Client Off
Restart Network
Reset Network Setting
TCP/IP
IP Address X X X . X X X . X X X . X X X
MAC Address X X : X X : X X : X X : X X : X X
Projector X X - X X X X
Link Disconnected
6
4
2
3
1
5
1 Setting a Password
If you do not want others to change the setting
for the “Network” menu, set a password.
a Setting a Password
1
Select “Password”, then press
ENTER or Q.
The screen for entering the password
appears.
Setting the Password
Old Password
New Password
Reconfirm
–
– – – –
– – –
– – – –
Network
2 Press P or R to set the fi rst digit
in “New Password”, then press Q.
3
Enter the remaining 3 digits, then
press
ENTER.
To return to the previous digit, press O.
4
Enter the same password in
“Reconfi rm”, then press
ENTER.
The status for “Password” changes to
“Enable”.
Once the password is set, you must enter the
password to change the “Network” menu
settings. •
Note
a Changing the Password
1
Select “Password”, then press
ENTER or Q.
The screen for entering the password
appears.
•
•
•
•
1
2
3
4
1
2
Enter the password in “Old
Password” using P, R, Q and O,
then press
ENTER.
3 Enter the password in “New
Password” using P, R, Q and O,
then press
ENTER.
4
Enter the same password again
in “Reconfi rm” using P, R, Q and
O, then press ENTER.
If you do not need the password protection
for the “Network” menu settings anymore,
press ENTER without entering the new
password in steps 3 and 4.
To cancel the password settings, press
RETURN. •
•
Note
If you forget the password
If you forget the password, perform the
following procedure to delete it, then set a
new password.
On the projector, press
.
If ENTER is held down for more than 5
seconds, the operation buttons on the
projector will be locked. (See page
52 .)
You cannot use the buttons on the
remote control to delete the password.
•
•
Note
2
3
4