Sanyo C0951 - Manual (Page 42)

39
7-2. Remote Control Unit Installation
Position
The remote control unit can be operated from either a
non-fixed position or a wall-mounted position.
To ensure that the air conditioner operates correctly, do
not install the remote control unit in the following places:
● In direct sunlight
● Behind a curtain or other place where it is covered
● More than 26 ft. (8 m) away from the air conditioner
● In the path of the air conditioner’s airstream
● Where it may become extremely hot or cold
● Where it may be subject to electrical or magnetic
interference
7-2-1. Mounting on a Wall
a) Removable mounting
1) Momentarily hold the remote control unit at the
desired mounting position.
2) Confirm that the air conditioner responds cor-
rectly when you press keys on the remote con-
trol from that position.
3) After confirming correct operation, use a screw-
driver to screw the supplied special mounting
screw into the wall. (Fig. 6)
4) Hang the remote control unit from the mounting
screw.
b) Non-removable mounting
1) Momentarily hold the remote control unit at the
desired mounting position.
2) Confirm that the air conditioner responds cor-
rectly when you press keys on the remote con-
trol from that position.
3) After confirming correct operation, use a screw-
driver to screw the mounting screw into the wall.
(Fig. 6)
4) Remove the remote control cover by sliding it
downward.
5) Remove the batteries of the remote control unit.
6) Use a screwdriver to screw the remote control
unit securing screw into the wall through the hole
in the battery compartment. (Fig. 7)
7) Replace the batteries.
8) Again confirm that the remote control unit oper-
ates correctly.
Wall
Screw
(Packed in indoor unit)
Fig. 7
Wall
Special
mounting
screw
(Packed in indoor unit)
Fig. 6
Removable mounting
Non-removable mounting
000-215 SM (1-56) 7/5/00 2:49 PM Page 39