Sony KD-34XBR970 - Manual (Page 18)

11
SE
TUP
Setu
p
SETUP
SE
TUP
SETU
P
SETU
P
KD-34XBR970
2-671-222-21(1)
Satellite Receiver To connect a satellite receiver
1 Connect the satellite antenna cable to the satellite receiver’s
satellite input jack.
2 Use an A/V cable to connect the satellite receiver’s A/V output
jacks to the TV’s A/V input jacks.
3 Connect a CATV cable from your cable or antenna to the TV’s
CABLE jack.
4 Run Auto Program, as described in “Setting Up the Channel List”
on page 20.
Notes on Using This Connection
Using
S VIDEO jacks?
See page 7.
To Do This ... Do This ...
Watch the satellite receiver Press TV/VIDEO repeatedly to select the satellite receiver input
(VIDEO 1 in the illustration).
Set up the TV remote control to operate the
satellite receiver If you have a non-Sony satellite receiver, you must program
the remote control. See “Programming the Remote Control”
on pages 24-25.
Activate the TV remote control to operate
the satellite receiver Press SAT/CABLE FUNCTION .
Control satellite receiver functions with the
TV remote control See “Operating a Satellite Receiver” on page 26.
Label video inputs to easily identify
equipment connected to the TV See the instructions for setting up Video Labels on page 45.
DIGITAL
AUDIO
OUT
DIGITAL
AUDIO
OUT
PCM/ PCM/
DOLBY DIGIT
DOLBY DIGITAL AL Satellite antenna
cable
A/V cable
CATV cable/antenna
TV
Satellite receiver
Cables are often
color-coded to connectors.
Connect red to red,
white to white, etc.