Sennheiser CONFERENCE SYSTEM SDC 8000 - Manual (Page 82)

Configuring the SDC 8000 system
82
Testing the consoles’ built-in loudspeakers
Via the “ Test Tone ” menu item, you can check if the consoles are
connected correctly and if the consoles’ built-in loudspeakers are working
correctly.
To activate the test tone:
̈
From the central unit’s operating menu, choose “ Conference ”,
“ Options ” and “ Test Tone ” one after the other.
̈
Choose “ Status = On ”.
All loudspeakers produce the test tone.
̈ To change the volume of the test tone, choose “ Level ”. You can choose
between “ High ” and “ Low ”.
̈ To change the volume of the test tone, choose “ Frequency ”. You can
choose between “ High ” and “ Low ”.
̈
To deactivate the test tone, choose “ Status = Off ” and press the
ENTER key.
The test tone is deactivated.
Testing the consoles’ microphones
Via the “ Test Units ” menu item, you can check if the consoles’
microphones are working correctly
To activate the microphones:
̈
From the central unit’s operating menu, choose “ Conference ”,
“ Options ” and “ Test Units ” one after the other.
̈
Choose “ Status = On ”.
̈
All microphones are activated one after the other in the order in which
the consoles were initialized. The red signal light ring of the currently
active microphone lights up. After all microphones have been activated
once, activation re-starts with the first microphone.
Activating/deactivating the flashing of the signal light ring
If – in “ With Request ” or “ With Req. No Clear ” mode – a participant presses
the MICRO key on his console, he makes a request to speak and the green
“Request to speak” LED
ƻ
starts flashing.
To activate the flashing of the signal light ring on all consoles:
̈
From the central unit’s operating menu, choose “ Conference ”,
“ Options ” and “ Light Ring ” one after the other.
̈
Choose “ Blink in request ” and press the ENTER key.
If a particpant makes a request to speak, the red signal light ring and
the green “Request to speak” LED
ƻ on his console start flashing.
To deactivate the flashing of the signal light ring on all consoles:
̈
Choose “ Off ”.
If a particpant makes a request to speak, only the green “Request to
speak” LED
ƻ
on his console starts flashing.
Options
1 Test Tone
Options
2 Test Units
Options
3 Light Ring