Sennheiser CONFERENCE SYSTEM SDC 8000 - Manual (Page 94)

Configuring the SDC 8000 system
94
Configuring the audio inputs and outputs
You can connect external audio sources such as a CD player, a microphone
with preamplifier etc. to the central unit’s audio inputs.
Instead of connecting an external audio source, you can connect the audio
output of a conference system installed in a separate room to carry out a
remote conference.
Via the audio outputs, you can connect e.g. a recording unit.
Via the “ Aux-In/Out ” menu, you can configure the central unit’s audio
inputs and outputs for the connected equipment.
Choosing the audio inputs and outputs
The central unit features five audio outputs.
The output signal of the floor channel is always available at the two
outputs AUX OUT 1 (XLR-3M audio output
µ
) and AUX OUT 2 (pin 1 and
6 of the 9-pole sub-D socket
ƺ
).
The outputs AUX OUT 3 - 4 - 5 are available at the 9-pole sub-D socket
ƺ
(for the pin assignment of this socket, please refer to page 51).
The two inputs AUX IN 1 and AUX IN 2 are available at the two XLR-3F
sockets
º and ¾ .
To choose the audio output or input to be configured:
̈
From the central unit’s operating menu, choose “ Aux-In/Out ”.
̈
Then choose between the following inputs and outputs:
y Aux Out 1 & 2
y Aux Out 3
y Aux Out 4
y Aux Out 5
y Aux In 1
y Aux In 2
̈
Press the ENTER key to active the menu item.
Adjusting the volume of the audio outputs
To set the volume of the output signal available at one of the audio
outputs:
̈
From the central unit’s operating menu, choose “ Aux-In/Out ”.
̈
Choose the desired audio output.
̈
Choose “ Volume ”.
The current volume is shown on the display.
̈
Adjust the volume and press the ENTER key to save your setting.
º ¾ µ ƺ
Aux-In/Out
1 Aux Out 1 & 2
Aux Out 3
1 Volume
Aux Out 3
Volume = 00
Press ENTER to Save