Speco Technologies PC Pro Series - Manual (Page 49)

41
(1)
(2)
(3)
(4)
(7) Configuration
Backup a copy of all the settings and allows you to regain the same settings back. To save the
current settings, click Export. To replace the settings with the one you have saved, click Import.
(8) System Controller Setup
To configure the parameters that is for communicating with the System Controller (an optional
accessory). Also please refer to user manual of the System Controller.
Enable – Mark the check box to enable the System Controller function.
Model – Select model of the System Controller.
Port – Select the com port that is connected with the System Controller. Click Setup to
configure com port value. The com port value is shown in below table:
Baud rate 9600
Data bits 8
Parity No
Stop bit 1
Flow control No
ID – Set an ID for DVR server (0~99). This ID is a key for communicating between the System
Controller and the DVR server.
i When the DVR server ID is X, the DVR server can be controlled by System Controller
irrespective of the DVR ID that is selected in System Controller.