Speco Technologies PC Pro Series - Manual (Page 61)

53
- No Recording
The system won’t do any recording.
(3) Enable Audio
Select to assign the audio channel of the selected camera. You can only assign one audio channel
to one camera source. This way you can record both audio and video.
(4) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is
detected. When it detects motion, a green triangle mark would appear at the upper left corner of
the screen.
(5) Voice Detection
Adjust the intensity of the audio detector. The system detects sound when it exceeds the intensity
value.
(6) Quality
Adjust the video quality. The higher the value, the lower the compression level and uses more hard
disk space.
(7) Frame Rate
Set the maximum and minimum number of frames to be recorded during motion and motionless
state. The frame rate ranges from 1 to 30 for NTSC and 1 to 25 for PAL. The higher the frame rate,
it uses more hard disk space.
(8) Video Size
Select the size of the video and click the ~ button. The higher the size, the larger the file it create.
You can also activate the Enable Deinterlace to enhance the video quality. Set the Enable
Deinterlace
mode to #1, if you are capturing motionless picture and #2, if it captures lots of
movement.
(9) Video Screen
Display the video of the selected camera
(10) Mask/Shield Edit
Mask, mark an area on the screen to disregard the motion in the marked area and to only monitor
outside the marked area. As for the Shield, it covers an area on the screen and the covered area
would not be visible on the screen and recorded. (see also
Chapter 4.3.1 and 4.3.2 )
(11) Compression Type
You can encrypt the recorded video that way only the person who
knows the password can clearly view the video playback. The file
size would become 10 to 30% more. Enabling the Video
Encryption check box, you will be prompted to enter the password
and retype the password for confirmation. Make sure not to forget
the password for you would not be able to decrypt the video
without it.
The symbol would appear on the upper right of the encrypted
video screen. You may see the video during live recording (see
also
Chapter 4.3.3 ).