Sony CDP-XE530 - Manual (Page 14)

Recording From CDs
14 GB
Recording a CD by Specifying
Tape Length (Time Edit)
(CDP-XE530 only)
You can have the player create a programme that will
match the length of the tape. In this feature, the player
creates a programme basically keeping the original
order of the disc. However, the player may change the
last track of each side to match the recording time to
the tape length.
i.e. Side A: track number 1n2n3n4n8
Side B: track number 5n6n7n9n10
The programme may contain up to 24 tracks (a pause
inserted between tracks is counted as one track).
Note that tracks numbered over 24 cannot be
programmed in this feature.
EDIT/TIME FADE 0/)
Recording Your Own
Programme
You can record the programme you’ve created on a
tape, DAT, or MD. The programme can contain up to
24 tracks.
By inserting a pause during programming, you can
divide the programme into two for recording on both
sides of a tape.
• CDP-XE530
• CDP-XE330
≠ AMS ±
· P PLAY MODE
PLAY MODE · P
1
Create your programme (for side A when
recording on a tape) while checking the total
playing time indicated in the display.
Follow Steps 1 to 4 in “Creating a programme on
the player” on page 12 or Steps 1 and 2 in
“Creating a programme using the remote” on page
13.
The “TAPE A” (or indication for the
CDP-XE330) appears in the display.
2
When you record on both sides of the tape, press
P to insert a pause.
The “P” and “TAPE B” (or indication for the
CDP-XE330) appear in the display and the playing
time is reset to “0.00.”
When you record on one side of the tape or on a
DAT or MD, skip this step and go to Step 4.
A pause is counted as one track
You can programme up to 23 tracks when you insert a
pause.
3
Repeat Step 1 to create the programme for side B.
≠ AMS ±
4
Start recording on the deck and then press · on
the player.
When you record on both sides of the tape, the player
pauses at the end of the programme for side A.
5
When you record on side B, reverse the tape and
press
· or P on the player to resume playing.
To check and change your programme
See page 13.
The “TAPE A” (or indication for the CDP-XE330)
appears while checking the programme for side A and
“TAPE B” (or indication for the CDP-XE330)
appears while checking the programme for side B.
When tracks, which aren’t numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
·
P
A
A
B
A B