Control knobs, Care and cleaning of the range – Sharp JB940 User Manual

Page 27

Advertising
background image

Safety Instructions

Operating Instructions

Safety Instructions

Operating Instructions

Care and Cleaning

Troubleshooting T

ips

Customer Service

Care and cleaning of the range.

Be sure all controls are off and all surfaces are cool before cleaning any part of the range.

Control Knobs

The control knobs may be removed for easier
cleaning.

Before removing the knobs for cleaning,

please note that the knobs are in the
OFF

position. When replacing the knobs,

check the OFF position to insure proper

placement.
Wash the knobs in soap and water or a

vinegar and hot water solution but do

not soak.

How to Remove Packaging Tape

To assure no damage is done to the finish

of the product, the safest way to remove

the adhesive left from packaging tape on

new appliances is an application of a

household liquid dishwashing detergent,

mineral oil or cooking oil.

Apply with a soft cloth and allow to soak.

Wipe dry and then apply an appliance

polish to thoroughly clean and protect

the surface.
NOTE: The plastic tape (on some models) must
be removed from all chrome trim. It cannot be
removed if it is baked on.

If your range is removed for cleaning, servicing or any reason, be sure the anti-tip
device is re-engaged properly when the range is replaced. Failure to take this
precaution could result in tipping of the range and cause injury.

Control Panel

Deactivate the touch pads before cleaning.

See the Cooking/Self-Clean lockout

information in the Special features of
your oven control

section in this manual.

Clean up splatters with a damp cloth.
You may also use a glass cleaner.

Remove heavier soil with warm soapy

water. Do not use abrasives of any kind.
Reactivate the touch pads after cleaning.

See the Cooking/Self-Clean lockout

information in the Special features
of your oven control

section in this

manual.

Oven Vent

The oven vent is located behind the right rear
surface unit.

This area could become hot during

oven use.

It is normal for steam to come out of the

vent and moisture may collect

underneath it when the oven is in use.
The vent is important for proper air circulation.
Never block this vent.

5

Molded flat area

Flat

Flat Stem

27

Spring clip

Clear groove

in stem

Molded rib

Groove Stem

The knob stem has a groove in each

side. The groove on one side has a

spring clip. The other groove is clear

(see illustration). Check the inside of

the knob and find the molded rib.

Replace the knob by fitting the molded

rib inside the knob into the clear

groove on the stem.

The knob stem is flat on one side (see

illustration). Check the inside of the

knob and find the molded flat area.

Replace the knob by fitting the molded

flat area inside the knob onto the flat

area of the stem.

Advertising
This manual is related to the following products: