Sony CMT-CP33MD - Manual (Page 24)

24
Programing CD tracks
(continued) To check the program order
Press . or > repeatedly during Program
Play.
To Do this
Last programed
track number Total playing time
5
To program additional tracks, repeat
steps 3 and 4.
6
Press N.
Program Play starts.
All the tracks play in the order you selected.
To check the total number of
programed tracks
Press DISPLAY in stop mode. The total number
of programed steps appears, followed by the last
programed track number and the total playing time
of the program.
Last programed
track number Total playing time
of the program
Cancel
Program Play Press x, then press PLAY MODE
repeatedly until “PGM” and
“SHUFFLE” disappear.
Add a track to
the program
(in stop mode) Perform steps 3 and 4.
Erase the entire
program
4
Press ENTER/YES.
The track is programed.
“Step” appears, followed by the number of
the track in the programed sequence. The
number of the last programed track appears,
followed by the total playing time of the
program. If you have made a mistake, you
can clear the last programed track from the
program by pressing CLEAR.
Press x, when Program Play is in
stop mode.
To select the desired track using
the number buttons on the
remote
Press number buttons instead of performing steps
3 to 5.
To enter track numbers 10 or over, press >10 and
the track number. To enter 0, use the 10/0 button.
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press
N.
• “Step Full” appears when you try to program 26 or
more tracks (steps).
• “--.--” appears when the total CD program time
exceeds 100 minutes, or when you select a CD track
whose number is 21 or over.