4 items in the extended setup menu – Sony DVW-2000 User Manual

Page 122

Advertising
background image

12-4

Items in the Extended Setup Menu

Chapter 12

Setup Menus

12-16

Chapter 12

Setup Menus

Menu items in the range 600 to 699, relating to the time code generator

Item number

601

602

603

604

605

Item name

VITC POSITION SEL-1

VITC POSITION SEL-2

ID CODE PRESET

ID CODE SW

TCG REGEN MODE

Settings

In 525-line mode
Select a line to insert the VITC in.
12H ... 16H ... 20H: Select any line from 12 to 20.

Note

You can insert the VITC signal in two places. To insert it in two places, set both
items 601 and 602.

In 625-line mode
Select a line to insert the VITC in.
9H ... 19H ... 22H: Select any line from 9 to 22.

Note

You can insert the VITC signal in two places. To insert it in two places, set both
items 601 and 602.

In 525-line mode
Select a line to insert the VITC in.
12H ... 18H ... 20H: Select any line from 12 to 20.

Note

You can insert the VITC signal in two places. To insert it in two places, set both
items 601 and 602.

In 625-line mode
Select a line to insert the VITC in.
9H ... 21H ... 22H: Select any line from 9 to 22.

Note

You can insert the VITC signal in two places. To insert it in two places, set both
items 601 and 602.

Select whether or not to set the ID code.
OFF : Do not set the ID code.
ON: Set the ID code.
To set the ID code:
Press the F5 (SET) button with this menu item displayed in the menu display, to
enter the ID code setting mode. You can then set the user ID digit by digit using
the

T and t buttons for digit selection. When all required digits have been set

correctly, press the F5 (SET) button again to save the ID code and exit from the
ID code setting mode.

Select whether or not to record the ID code set using item 603 in the user bits.
OFF : Record the normal data in the user bits.
ON: Record the ID code in the user bits.

Select the signals to be regenerated when the time code generator is in the
regeneration mode (i.e., when the function menu item TCG (F2) is set to
REGEN).
TC&UB : Both the time code and user bit signals are regenerated.
TC: Only the time code signal is regenerated.
UB: Only the user bit signal is regenerated.

Advertising
This manual is related to the following products: