Sony DVW-2000 - Manual (Page 136)

12-4 Items in the Extended Setup Menu
Chapter 12
Setup Menus
12-30
Chapter 12 Setup Menus
Menu items in the range 900 to 999, relating to digital processing
Item number
901
903
904
905
906
920
Item name
VIDEO OUTPUT DATA
FREEZE MODE
FREEZE CONTROL
FROM KEY PANEL
AUTO FREEZE
CONTROL
STOP FREEZE
CONTROL
SD-SDI H-ANC
Sub-item
1 AUDIO 5CH-8CH
(DVW-M2000/
M2000P only)
2 RP-188 ATC
Settings
Set the bit length for SDI video output data.
8bit: Set the bit length to 8 bits.
10bit : Set the bit length to 10 bits.
It is recommended that you select the optimal setting for the device to which you
are going to connect this unit.
Select the freeze mode and freeze timing.
FIELD : Freeze a video field. Field may be odd or even, according to the timing.
FLD1: Freeze an odd field.
FLD2: Freeze an even field.
FRM12: Freeze a frame consisting of an odd field and following even field.
FRM21: Freeze a frame consisting of an even field and following odd field.
Odd and even fields are distinguished by the reference video signal.
Changing the menu setting during a freeze does not affect the freeze image.
The setting is reflected the next time a freeze is carried out.
You can freeze an image using the DELETE button and TRIM + button.
For details, see menu item 904.
Determine how the buttons used to freeze an image function.
MOMNT : Holding the DELETE button and pressing the TRIM + button carries out
a freeze. The freeze ends when the buttons are released.
LATCH: Holding the DELETE button and pressing the TRIM + button carries out
a freeze. The freeze continues even after the buttons are released.
• To update the freeze image
Hold the DELETE button and press the TRIM + button again.
• To end the freeze
Hold the DELETE button and press the TRIM – button.
Set the auto freeze function operation (conditions for ending a freeze, etc.).
In normal playback, if there is a sudden worsening of the channel condition (entry
into unrecorded area), this function freezes the image.
DIS : Disable the auto freeze function.
MODE1: End the freeze when signals which can be recorded normally are
restored.
MODE2: End freeze automatically on playback after stopping.
• The automatic freeze mode is determined by item 903.
• The freeze is ended immediately, regardless of the above conditions, when this
unit is switched to any of the following modes:
Eject
EDIT preset on
Cue up
Recording
Select whether or not the STOP FREEZE function should operate.
DIS : Does not operate.
ENA: Operates.
Select whether or not to add information to the SDI output.
ON
OFF
ON
OFF
Select whether to add digital audio data channels 5 to 8 (ON), or not (OFF).
Select whether to add RP-188 time code data (ON), or not (OFF).