Sony VAIO VPCZ2 - Manual (Page 99)

99 n N
Using Your VAIO Computer >
Using the TPM
To unlock the encrypted data with a recovery key stored on a USB flash memory device
To unlock the encrypted data with a recovery key stored on a USB flash memory device, your system needs to access the
USB flash memory device when you boot the computer. Follow these steps to configure the boot order in the BIOS setup
screen:
1 Connect a USB flash memory device.
2 Turn on the computer and press the F2 key repeatedly until the VAIO logo disappears.
The BIOS setup screen appears. If the screen does not appear, restart the computer and try again.
!
The VAIO logo does not appear when Fast BIOS Startup Settings on the VAIO Control Center is enabled. Disable the settings with the VAIO Control
Center
(page 165) .
3 Press the < or , key to select the Security tab, the M or m key to select Change TPM State, and then the Enter key.
4 Press the M or m key to select Enable and then the Enter key.
5 Press the < or , key to select Boot and then select Enabled for External Device Boot.
6 Press the M or m key to select Boot Priority and then the Enter key.
7 Press the F5 or F6 key to change the boot device order so that Internal Hard Disk is listed higher than External Device.
!
You need to move Internal Optical Drive to the top of the list to recover the computer system using your Recovery Media.
8 Press the < or , key to select Exit, select Exit Setup, and then press the Enter key.
9 After your system restarts, select Execute in the confirmation window and then press the Enter key.
10 Follow the instructions in Windows Help and Support to enable BitLocker Drive Encryption.
11 Save the recovery password to the USB flash memory device in the window for saving the recovery password.
12 Follow the on-screen instructions.
The encryption process will start.