Sharp VL-WD450U - Manual (Page 30)

15
Preparation
Preparation
MENU/DISPLAY button
Power switch
Operation button
LCD monitor OPEN
release button
D I SPL AY
DY L T SAVE
ARE A
SE T T I NG
1 2 H 2 4 H
L ONDON 1
C L OCK SE T
NEW YORK 2 0
D I SPL AY
DY L T SAVE
ARE A
SE T T I NG
1 2 H 2 4 H
C L OCK SE T
J AN .
1 2 0 0 AM :
1 2 0 0 1 .
D I SPL AY
DY L T SAVE
ARE A
SE T T I NG
1 2 H 2 4 H
C L OCK SE T
JUN.
1 2 0 0 AM :
1 2 0 0 1 . SE T T I NG
JUN.
1 2 0 0 AM :
2 2 0 0 1 . SE T T I NG
Setting the Area, Date and
Time
Example: Setting the date to June 2, 2002
(JUN. 2. 2002) and the time to 10:30 am
(10:30 AM) in New York.
Notes:
• Before performing the procedure below, make
sure that the lithium battery has been installed
(see page 13).
• If you are in an area that observes daylight
saving time, set the time to the standard time.
You can then correct it for daylight saving time
by performing the procedure on page 59.
1
Press the LCD monitor OPEN release
button (
1 ) and open the LCD monitor
( 2 ).
2
Hold down the Lock button
and set the Power switch to
CAMERA.
4
Press r on the Operation button.
5
Press d or y ( 1 ) until “20 NEW
YORK” appears, then press e ( 2 ).
Note:
• See “Time Zone Chart” and “Area Table” on
pages 57 and 58 for the area number and
name of the representative city for your time
zone.
6
Press d or y ( 1 ) to select
“SETTING” , and then press r ( 2 ).
7
Press d or y to select “JUN”
(month), and then press r .
8
Press d or y to select “2” (day), and
then press r .
3
Press the MENU/DISPLAY button until
the menu screen appears.
Lock button