Windbreak, Setting the confirmation sounds, On w i nd – Sharp VL-WD450U User Manual
Page 71
56
Advanced Features
Windbreak
The windbreak function allows you to reduce
annoying noise from strong winds when
recording.
1
Set the camcorder to TAPE-CAMERA
mode.
2
Press the MENU/DISPLAY button until
the menu screen appears.
3
Select
U
, then press
r
on the Opera-
tion button. Select “WIND” (
1
), then
press
r
(
2
).
OF F
ON
AUD I O MODE
W I ND
Z OOM M I C
AUD I O SE T
4
Press
d
or
y
to select “ON”, then
press
e
.
ON
W I ND
5
Press the MENU/DISPLAY button to
turn off the menu screen.
To cancel Windbreak
Select “OFF” in step 4 above.
Note:
• Keep the windbreak function off during normal
recording. If it is left on, the recorded audio may
sound somewhat muffled when played back.
Setting the Confirmation
Sounds
A confirmation sound is made when you turn
on or off the Power switch, press the REC
START/STOP button, or perform other desig-
nated operations. Use the procedure below to
change the type of sound or to turn off the
confirmation sounds altogether.
Type of Confirmation Sound
Settings
CHIME:
A chiming sound is made.
BEEP:
An electronic beeping sound is made.
OFF:
No confirmation sound is made.
1
Press the MENU/DISPLAY button until
the menu screen appears.
2
Select
I
, then press
r
on the
Operation button. Select “SOUND” (
1
),
then press
r
(
2
).
B E E P
OF F
CH I ME
REMO T E
SOUND
T I ME CODE
T C OUT
DEMO MODE
L ANGUAGE
OT HERS
3
Press
d
or
y
to select the desired
sound setting, then press
e
.
B E E P
SOUND
4
Press the MENU/DISPLAY button to
turn off the menu screen.
Note:
• If “OFF” is selected, the sound effect of a
camera shutter closing in PHOTO SHOT mode
and CARD-CAMERA mode will also be turned
off.