Sharp VL-WD450U - Manual (Page 8)

vii
Tape Playback
1
Press the LCD monitor OPEN release
button (
1 ), and open the LCD monitor
to a 90° angle to the camcorder body
(
2 ).
2
Adjust the LCD monitor to an angle that
allows easy viewing on the on-screen
picture.
To stop playback
Press d .
90
3
Set the Media Selection
switch to TAPE.
4
Hold down the Lock button
and set the Power switch to
VCR.
5
Press e (or r ) on the Operation
button to rewind (or fast forward) the
tape to the desired point.
6
Press y to begin playback.
AUDIO1 2 +
AUDIO1 2 +
Quick Operation Guide
Easy Camera Recording on
Tape
1
Make sure that a cassette is inserted.
5
Press the REC START/STOP button to
begin recording.
2
Remove the lens cap, and lift up the
viewfinder.
3
Set the Media Selection
switch to TAPE.
4
Hold down the Lock button
and set the Power switch to
CAMERA.
Lock button
RE C
Power Zoom
control
Zooming
Push the Power Zoom control to T ( 1 )
(telephoto) or W ( 2 ) (wide angle) side.
LCD monitor OPEN
release button
Lock button