Servis-Rhino LUMBERJACK 60/72 - Manual (Page 108)

OPERATION
LJ60/72 02-02 Operation Section 4-34
OPERA
TION
© 2004 Alamo Group Inc.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE REMEDY
NOT CUTTING CLEAN Blades dull. Sharpen or replace Blades.
Blade rotation incorrect. Use correct Blade for Carrier.
Carrier RPM too low. Increase PTO speed.
Mower not leveled. Adjust machine level
Ground speed too fast. Reduce ground speed.
Blades locked back. Free Blades.
Blades riding up due to Replace Blade Bolts
blade bolt wear.
Blades bent up.
Replace Blades.
BREAKING BLADE Operating with loose Tighten Blade Bolts to 400 ft. lbs.
BOLTS Blade Bolts.
Worn Blade Bolt.
Replace Bolt.
CUTTING TOO HIGH Blades bent up. Replace Blades.
Blade Bolt Bushing broken Replace or reweld Bushing. Weld
or loose. with E7018 low Hydrogen rods.
Blade Carrier bent. Straighten or replace Blade Carrier.
Blades on upside down. Turn Blades right side up and tighten.
CUTTER VIBRATES Blade locked back. Loosen locked Blade.
Drivelines not phased. Replace Driveline.
Blade broken. Replace Blades in sets.
Blade Carrier bent. Repair or replace Carrier.
Blade Hub not properly Remove Hub, check Shaft,
seated on Shaft. and replace or seat properly.
New Blade matched with Replace Blades in sets
worn Blade.
CUTTER WINDROWING Cutting heavy material. Raise Cutter and reduce ground speed.
BLADES WEAR FAST Cutting in sandy or rocky Increase cutting height.
conditions.
Blades too soft.
Replace Blades; with hardened,
high-quality, Rhino Blades from the .
manufacturer.
BLADE BOLTS Bolts not tightened. Tighten Bolts to 400 ft. lbs.
WORKING LOOSE Bolt hole elongated or Replace Bushing or replace
oversized. Blade Carrier.
Locknut worn out. Replace Locknut.