Servis-Rhino LUMBERJACK 60/72 - Manual (Page 16)

Safety Section 1-10 LJ60/72 02-02
© 2004 Alamo Group Inc.
SAFETY
SAFETY
PARTS INFORMATION
Servis-Rhino mowers use balanced and matched system components for blade carriers, blades, cuttershafts,
knives, knife hangers, rollers, drivetrain components, and bearings. These parts are made and tested to
Servis-Rhino specifications. Non-genuine "will fit" parts do not consistently meet these specifications. The
use of “will fit” parts may reduce mower performance, void mower warranties, and present a safety hazard.
Use genuine Servis-Rhino mower parts for economy and safety.
(SPRM-1)
SEE YOUR SERVIS-RHINO DEALER
In addition to the design and configuration of this Implement, including Safety Signs and Safety Equipment,
hazard control and accident prevention are dependent upon the awareness, concern, prudence, and proper
training of personnel involved in the operation, transport, maintenance, and storage of the machine. Refer also
to Safety Messages and operation instruction in each of the appropriate sections of the Tractor and Equipment
Manuals. Pay close attention to the Safety Signs affixed to the Tractor and Equipment.
(SG-18)
Follow these guidelines to reduce the risk of equipment and grass fires
while operating, servicing, and repairing the Mower and Tractor:
-Equip the Tractor with a fire extinguisher in an accesible location.
-Do Not operate the Mower on a Tractor with an underframe exhaust.
-Do Not smoke or have an open flame near the Mower and Tractor.
-Do Not drive into burning debris or freshly burnt areas.
-Ensure slip clutches are properly adjusted to prevent excessive slippage
and plate heating.
-Never allow clippings or debris to collect near drivelines, slip clutches,
and gearboxes. Periodically shut down the Tractor and Mower and clean
clippings and collected debris from the mower deck.
(SGM-12)
WARNING!
WARNING! Do not mow with two machines in the same area except with Cab tractors with the windows closed.
(SGM-11)
DANGER! Replace bent or broken blade with new blades. NEVER ATTEMPT TO STRAIGHTEN OR WELD
ON BLADES SINCE THIS WILL LIKELY CRACK OR OTHERWISE DAMAGE THE BLADE
WITH SUBSEQUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN BLADES.
(SGM-10)