Servis-Rhino LUMBERJACK 60/72 - Manual (Page 79)

OPERATION
LJ60/72 02-02 Operation Section 4-5
OPERA
TION
© 2004 Alamo Group Inc.
2.1 ROPS and Seat Belt
A Roll-Over-Protective-Structure (ROPS) and seat belt are essential to protect the operator from falling off the
tractor, especially during a roll over where the driver could be crushed and killed. The ROPS and seat belt must
be used in conjunction with one another. Only operate the tractor with the ROPS in the raised position and seat
belt fastened. Tractor models not equipped with a ROPS and seat belt should have these life saving features
installed by an authorized tractor dealer.
2.2 Tractor Safety Devices
I f transporting or operating the tractor and cutter near a public roadway, the tractor must be equipped with proper
warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of the unit.
Lights and a SMV emblem must be equipped directly on implements if the visbility of the tractor warning signals
are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or cutter. Never operate the tractor PTO with the
PTO master shield missing or in the raised position.
2. TRACTOR REQUIREMENTS
The tractor used to operate the cutter must have the power capacity to lift, pull, and operate the Power Take Off
(PTO) at the required speed (540 or 1000 revolutions per minute, depending on cutter gearbox) while traveling
at a ground speed between 1 and 3 mph. Operating a cutter with a tractor that does not meet the following
requirements may cause tractor or cutter damage and be a potential danger to the
operator and passersby.
Tractor Requirements and Capabilities
" ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
" Tractor Safety Devices...…….................................. Slow Moving Vehicle (SMV) emblem, lighting,
PTO master shield
" Tractor Horsepower-Minimum ….............................. LJ60-50HP; LJ72-90HP.
-Maximum…….........................125 HP
" 3-Point Hitch-Lifting Capacity.....................................LJ60-1650 lbs.; LJ72-2500 lbs.
-Category.................................................................. LJ60 - CAT II ; LJ72 - CAT II or CAT III
"
Front End Weight..…………………........................... As needed to maintain 20% weight on front axle
" Power Take Off...........……….................................... 540 rpm-6 spline or 1000 rpm-21 spline shaft
Operate this Equipment only with a Tractor equipped with an approved roll-over-
protective system (ROPS). Always wear seat belts. Serious injury or even death
could result from falling off the Tractor--particularly during a turnover when the
operator could be pinned under the ROPS.
(SG-7)
WARNING!