Servis-Rhino LUMBERJACK 60/72 - Manual (Page 114)

MAINTENANCE
Maintenance Section 5-4 LJ60/72 02-02
© 2004 Alamo Group Inc.
MAINTENANCE
DRIVELINE LUBRICATION
Grease Fittings are located on the Cross Assembly of each U-Joint and on the telescoping tubes. Grease the U-
Joint after each 8 hours of use. Figure 5. Grease the telescoping tubes after every 8 hours use. Some PTO-to-
Hitch connections may necessitate cutting a hole in the shields to be able to align the Grease Fitting holes for
lubrication. Lubricate the shield bearings every 16 hours. Figure 6.
CAUTION! Make certain that the Driveline Integral Shields are free to telescope and rotate around the
Driveline without binding.
FIGURE 5. U-Joint Lubrication
SHIELD RETAINING
SCREWS
SLIP
CLUTCH
DRIVELINE SHIELD
GREASE FITTING
FIGURE 6. Driveline Maintenance
OVERRUNNING CLUTCH TELESCOPING
TUBES