Sony SU-LW1 - Manual (Page 13)

13
(GB)
KLV-26HG2
Step 5: Detach the display from the Tabletop Stand
The procedure differs depending on the display model. Apply the procedure
appropriate for the display you are installing.
1 Pull the lower corner (either right or
left ) of the rear cover. Then pull the
other lower corner.
2 Hold the rear cover with both hands
and pull it towards you. The rear
cover will separate from the display.
Note
Lay the display face down on a soft cloth
before going to 3.
3 Remove the two small screws from
the clip. Detach the clip from the
Tabletop Stand.
4 Remove the five screws from the
Tabletop Stand.
5 Lift up the Stand slightly, then pull it
towards you. The Stand will separate
from the display.
Notes
• Lay the display face down on a stable
and level surface, leaving the base of
the Stand sticking out in the air.
Putting the display face and the base
of the Stand on the same level surface
makes the Display Unit inclined, thus
unstable, causing any danger.
• When removing the Tabletop Stand,
hold it firmly.
3
5
4
Soft cloth
Screws
removed in 4
1
2
Clip