Sony SU-LW1 - Manual (Page 16)

16
(GB)
Step 6: Install the display on the Plate Unit
WARNING
Do not connect the power cord to a wall socket before the installation is completed. If the mains lead is
pinched, a short circuit may occur, causing an electric shock.
Be careful not to stumble over the cables or the display.
1 Align the holes on the Mounting
Hook Units with the corresponding
holes on the rear of the display.
Secure them to the display using
four screws.
For the KLV-26HG2, use the screws supplied (+PSW5
×
L16). For the KDL-L32MRX1, the KLV-L32MRX1,
the KLV-30MR1, and the KLV-L32M1 use the screws
you removed in Step 5.
Notes
• Lay the display face down on a soft cloth.
• When using an electric screwdriver to tighten the
screws, the torque must be approx. 2 N • m.
KLV-26HG2
KDL-L32MRX1/KLV-L32MRX1/KLV-30MR1
The supplied screws
(+PSW5
×
L16)
Mounting Hook Units
Soft cloth
Rear of the display
The screws removed
in Step 5
Mounting Hook Units
Soft cloth
Rear of the display
KLV-L32M1
The screws removed
in Step 5
Mounting Hook Units
Soft cloth
Rear of the display