Symbol Technologies DS6707 - Manual (Page 121)

Chapter 8 RS-232 Interface
Chapter 8
Introduction
This chapter describes how to set up the digital imager scanner with an RS-232 host. The RS-232 interface is
used to connect the digital imager scanner to point-of-sale devices, host computers, or other devices with an
available RS-232 port (e.g., com port).
If the host is not listed in Table 8-2 , refer to the documentation for the host device to set communication
parameters to match the host.
Throughout the programming bar code menus, default values are indicated with asterisks (
*
).
NOTE T he digital imager scanner uses TTL RS-232 signal levels, which interface with most system
architectures. For system architectures requiring RS-232C signal levels, Symbol offers different
cables providing TTL-to-RS-232C conversion. Contact the Symbol Support Center for more
information.
*
Baud Rate 57,600 Feature/Option
*
Indicates Default
NOTE
Most computer monitors allow scanning the bar codes directly on the screen. When
scanning from the screen, be sure to set the document magnification to a level where the bar code
can be seen clearly, and bars and/or spaces are not merging.