Sony CDU926S - Manual (Page 12)

■ Ejecting a caddy manually in an emergency
In the event of electrical or mechanical failure of the drive unit, a manual
emergency eject is provided to allow removal of the caddy from the drive
unit.
1 Turn off the power of your computer.
2 Insert a pointed object, such as a paper clip, into the emergency eject
hole, and push with hand. (Typical required force is 46 N [4.7 kg])
After removing the caddy from the drive unit, consult your dealer or
qualified service personnel.
Operating the Drive 23
at least
35 mm at least 35 mm
In such a case, eject the caddy and re-insert it properly. If the busy
indicator remains lit amber, consult your dealer or qualified service
personnel. The busy indicator also lights amber during audio play.
However, this is not a malfunction.
Ejecting a Caddy
1 Turn on the power supply.
2 Press the eject button on the drive unit.
Notes:
● The eject button does not work if it is disabled by the software.
● To eject a caddy when the eject button is disabled by the software:
– Make sure that the jumper block’s PREVENT/ALLOW is set to ON.
– Turn the power of your computer off, and turn it on again. (Or reset
the SCSI bus using a software command.)
22 Operating the Drive