Sony SPK-HCD - Manual (Page 26)

26
Specifications
Sensitivity (at 50 dB quieting)
22.1 dBf, 7 µV (mono)
42.1 dBf, 70 µV (stereo)
Usable sensitivity 19.5 dBf, 5 µV (IHF)
Signal-to-noise ratio (at 75 kHz deviation)
80 dB (mono)
75 dB (stereo)
Separation 35 dB at 1 kHz
Selectivity 55 dB at 400 kHz
Harmonic distortion 0.3% (mono) at 1 kHz
0.5% (stereo) at 1 kHz
AM tuner section
Tuning range
530 – 1,710 kHz (10 kHz)
531 – 1,710 kHz (9 kHz)
Antenna AM loop antenna, External antenna
terminals
Intermediate frequency
450 kHz
Usable sensitivity AM loop antenna: 500 µV/m
(1,000 kHz)
Signal-to-noise ratio 54 dB
Harmonic distortion 0.5%
Selectivity 38 dB (10 kHz)
Tape Deck
System 4-track 2-channel stereo
Frequency response (DOLBY NR OFF)
With TYPE II cassette (Sony
UCX-S): 30 – 14,000 Hz (±3 dB)
With TYPE I cassette (Sony HF-S):
30 – 13,000 Hz (±3 dB)
Wow and flutter 0.12% WRMS (NAB)
Compact Disc
System Compact disc digital audio system
Laser Semiconductor laser
Wavelength 780-790 nm
Frequency response 2 Hz – 20 kHz (±1.5 dB)
Harmonic distortion Less than 0.03 % (1 kHz)
General
Power requirement 120 V AC, 60 Hz
Power consumption 240 W
Dimensions Approx. 430 x 410 x 400 mm (w/h/d)
(17 x 16
3 /
16
x 15 3 /
4
inches)
(including projecting parts and
controls)
Mass Approx. 15.2 kg (33 lb 9 oz) net
Accessories supplied
AM loop antenna (1)
FM wire antenna (1)
Remote Commander RM-U451 (1)
Sony batteries SUM-3(NS) (2)
Design and specifications are subject to change without
notice.
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8-ohm loads, both channels driven,
from 70 -20,000 Hz; rated 100 watts per
channel minimum RMS power, with less than
0.9% total harmonic distortion from 250
milliwatts to rated output.
Amplifier
Overall output 120 W + 120 W (front, at rear/center/
woofer off at 1 kHz, 8 ohms)
15 W + 15 W (rear, at center/woofer
off at 1 kHz, 8 ohms)
30 W (center, at rear/woofer off at
1 kHz, 6 ohms)
30 W (woofer, at rear/center off at
40 Hz, 4 ohms)
Harmonic distortion Less than 0.9% (at 1 kHz, 8 ohms
loads, front: 120 W + 120 W, rear/
center/woofer off)
Frequency response PHONO: RIAA curve
VIDEO 1/MD, VIDEO 2:
40 Hz – 50 kHz, ±3 dB
Input
Output
VIDEO 1/MD: Voltage 250 mV, impedance 1 kilohm
FRONT SPEAKERS: Accept speakers of 8 – 16 ohms
REAR SPEAKERS:
Accept speakers of 8 – 16 ohms
CENTER SPEAKERS :
Accept speaker of 6 – 16 ohms
SUPER WOOFER SPEAKERS:
Accept speaker of 4 – 16 ohms
HEADPHONES: Accept low and high impedance
Tone buttons BASS: Boost/cut range ±7 dB (100
Hz)
TREBLE: Boost/cut range ±7 dB (10
kHz)
Tuner
System FM stereo, FM/AM superheterodyne
tuner
Quartz-locked PLL digital
synthesizer system
FM tuner section
Tuning range
87.5 – 108 MHz
Antenna terminals 75 ohms unbalanced
300 ohms balanced
Intermediate frequency10.7 MHz
Sensitivity
2.5 mV
250 mV
PHONO
VIDEO 1/MD
VIDEO 2
Impedance
50 kilohms
50 kilohms