Kodak Ektagraphic III PAINTED and NON-PAINTED PROJECTORS J-E PLUS - Manual (Page 7)

Replacements and Installations
SM4530-1 – 30APR96 7
Installing the FAN SHAFT ASSEMBLY
Important
When installing the FAN and MECHANISM BELTS, install the MECHANISM BELT on the small MOTOR PULLEY,
and the FAN BELT on the large MOTOR PULLEY.
[1] Do the removal procedure for the FAN BELT and SHAFT in reverse order.
Replacing the MOTOR
Warning
Dangerous Voltage
[1] Disconnect the main power.
[2] Do the replacement procedure for the LOWER
HOUSING ASSEMBLY.
[3] Disconnect all wires from the MOTOR.
[4] Cut the 2 WIRE TIES on the SMALL CIRCUIT
BOARD between the MOTOR and MECHANISM
ASSEMBLY.
[5] Disconnect the 2 wires from the CYCLE
SOLENOID on the SMALL CIRCUIT BOARD.
[6] Pull the SMALL CIRCUIT BOARD up.
[7] Disconnect all wires on the MOTOR.
[8] Remove 3 Hex 1/4 in. SCREWS from the MOTOR.
[9] Lift the MOTOR up to allow access to the FAN and
MECHANISM BELTS.
[10] Remove the FAN and MECHANISM BELTS from
the MOTOR PULLEY.
[11] Remove the MOTOR.
A091_4015BA
A091_4015BCA MECHANISM BELT
FAN BELT
A091_4016GA
MOTOR
SCREW (3)
A091_4016GCA