Kyocera KX444 - Manual (Page 5)

User Guide for the Kyocera KX444 Phone v
Resetting the phone
If the screen seems frozen and the keypad does not
respond to keypresses, reset the phone by
completing the following steps:
1. Remove the battery door.
2. Remove and replace the battery.
If the problem persists, return the phone to the dealer
for service.
Accessories
Use only Kyocera-approved accessories with
Kyocera phones. Use of any unauthorized
accessories may be dangerous and will invalidate the
phone warranty if said accessories cause damage or
a defect to the phone.
To shop online for phone accessories, visit
www.kyocera-wireless.com/store.
To order by phone, call
(800) 349-4188 (U.S.A. only) or (858) 882-1410.
Radio frequency (RF) energy
Your telephone is a radio transmitter and
receiver. When it is on, it receives and sends out RF
energy. Verizon’s network controls the power of the
RF signal. This power level can range from 0.006 to
0.6 watts.
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure guidelines
with safety levels for hand-held
wireless phones. These guidelines are consistent with
the safety standards previously set by both U.S. and
international standards bodies in the following reports:
•
ANSI C95.1
(American National Standards Institute, 1992)
• NCRP Report 86 (National Council on Radiation
Protection and Measurements, 1986)
• ICNIRP (International Commission on Non-
Ionizing Radiation Protection, 1996)
Your phone complies with the standards set by these
reports and the FCC guidelines.
E911 Mandates
Where service is available, this handset complies with
the Phase I and Phase II E911 Mandates issued by
the FCC.
Battery and charger specifications
Qualified service
If the problem with your phone persists, return the
phone with all accessories and packaging to the
dealer for qualified service.
Become a product evaluator
To participate in the testing and evaluation of Kyocera
Wireless Corp. products, including cellular or PCS
phones, visit
beta.kyocera-wireless.com.
093 453 037
Kyocera Wireless Corp.
10300 Campus Point Drive, San Diego, CA 92121
U.S.A.
Visit us at www.kyocera-wireless.com
Charger Input Output
CV90-60858-
01 100-240VAC / 50/
60Hz 4.5V 1.5A
CV90-60859-1 120VAC / 60Hz 5.2V 400mA
Standard Battery: 3.6V / 900mAh
High Capacity Battery: 3.6V /1350mAh