Kensington MP-15E - Manual (Page 15)

15
Names and Functions of Each Section
■ Remote Control Operations
• Use the remote controller within about 6 meters(6.5 yd) from the remote control sensors (on
the front and rear sides) and within 30 degrees to the left and right. This distance may
become shorter as the battery wears down.
• The remote controller does not work if there are obstacles between the remote controller
and the remote sensor on the main unit.
Pay attention to the following when using the laser pointer:
• Do not look into the laser light.
• Do not point the laser light at people.
• Do not let children use the laser pointer.
■ Battery Replacement
1. Push up while pulling on the tab of the
cover.
2. Install two batteries in the battery com-
partment, making sure that they are
aligned as indicated by the (+) and (-)
marks.
3. Slide the cover into position on the
battery compartment.
CAUTION
Handling the remote controller
• Do not subject the remote controller to strong impact shock.
• Keep the remote controller away from water. Wipe the remote controller immediately if it gets wet.
• Avoid heat or hot water. Remove the dry cells when you are not using the remote controller for a long period of
time.
• Do not mix new and old dry cells, or use different types of dry cells at the same time.
• Do not disassemble or heat batteries, or throw them into a fire.
• Follow your local government's disposal instructions for used dry cells.
• The remote controller may not work when it is used near inverter-driven equipment.
• The remote controller may not work or may work ineffectively when it is used near inverter-driven fluorescent
lighting.
NOTE
• When replacing the battery, buy AAA batteries.
• Ni-Cad batteries or other chargeable batteries cannot be used. Use manganese batteries or alkaline batteries.