Kensington MP-15E - Manual (Page 28)

28
9
8
ON/STANDBY
LAMP
ALARM
Main Unit Operation
ON/STANDBY
Remote Control Operation
When You Have Finished Using the Projector
8
Turn the lamp off.
Press the ON/STANDBY button. (Hold down for at least one
second.)
“Press ON/STANDBY again to turn off.” is displayed on the
projection screen.
Press the ON/STANDBY button again.
The LAMP LED blinks (green), and goes out after about 120
seconds.
The power indicator LED lights (red).
NOTE
For one minute after the lamp lights, the lamp will not go out even if the ON/STANDBY button is pressed.
At this time, “Cannot light for one minute.” is displayed.
9
Disconnect the power cord.
The power indicator LED on the operation panel goes out.
CAUTION
• Do not disconnect the power cord before turning off the lamp or before the lamp LED goes out. Doing so
might shorten the life of the lamp.
• Disconnect the power cord from the power outlet if you are not going to use the projector for a long period of time.
• Allow at least about ten seconds before reconnecting the power supply after disconnecting the power cord.
NOTE
• Due to its characteristics, the lamp may not light if it is turned on immediately after it is turned off. Wait for
at least one minute before turning it on again.
• The lamp may emit a slight humming noise when it is turned on. This is not a malfunction.
ON/
STANDBY