Kensington MP-15E - Manual (Page 5)

5
• Clean the lens surface with a commercial blower or lens cleaning paper.
Wiping with tissue paper or a handkerchief can damage the lens.
• To clean the cabinet, operation panel, and glass surface, wipe gently with asoft
cloth. For particularly dirty spots, soak the cloth in a neutral detergent mixed in
water, wring out well and wipe off the dirt, then use a dry cloth to wipe dry.
• Do not wipe the projector with any volatile solvent such as benzine or thinner.
Solvents can cause surface deformation or flaking of the paint.
If using an impregnated cloth, follow the instructions.
• Avoid scratching the glass surface.
• Take care not to scratch the glass surface of the scanner with hard or pointed
objects.
Scratches on the glass may distort the projected image.
• Batteries
• When inserting batteries in the remote controller, note the poles (plus and
minus signs) and insert correctly as indicated. Inserting a battery in a wrong
direction can cause rupture or leakage, and may result in fire and injury or
soil the surrounding area.
• Do not use batteries other than the type specified for the equipment. Do not
use a new battery and an old battery together. Incorrect battery usage may
result in rupture or leakage, and may cause fire and injury.
• Do not heat, break open, burn, or immerse the batteries. Battery rupture or
leakage may cause fire and injury.
• Servicing and cleaning
• Have the internal components cleaned by a retailer about once a year.
There is a risk of fire or faulty operation if the inside of the projector gets
dusty and is not cleaned for a long time. For best effect, the projector should
be serviced before the wet season brings damp conditions. Cleaning charges
are at the discretion of the retailer.
• If not using the projector for a long period:
• If you do not plan to use the projector for a long time, pull out the power plug
for safety.
• Disposal
• Follow the recommendations of your local authority when disposing of the
projector.
• Transporting the projector
• Use the special packaging when transporting the projector. Nippon Avionics
Co. Ltd. cannot accept responsibility in the event of damage or accident if
other packaging is used.
• Use the special packaging no more than two times. Repeated usage reduces
the shock absorbency of the packaging and can lead to damage or accident.
• Contact the retailer if you reguire new packaging.
• Lamp implosion
• An DC type New Super High pressure lamp is used in this projector and it is
rare for the lamp to explode during use. The lamp is also designed to forcibly
turn off because there is a high possibility that the lamp breaks if it is used
beyond the lamp life of 1000 hours (Refer to pages 46 and 47).
Note the following things
•
A noise occurs because the internal pressure of the New Super High pres-
sure lamp gets extremely high.
The unit is designed so that no pieces of glass come out of it when the lamp
explodes.
• However, the gas inside of the lamp go out and looks like white smoke, it will
not lead to any fire.