Konftel G510-7276-00 - Manual (Page 81)

Menu item Description
NPA Mode
Off
Auto
Sets the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol
Notes:
• Auto is the factory default setting.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Network Buffer
Disabled
Auto
Controls the network input buffer
Notes:
• Auto is the factory default setting.
• The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
• Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is updated.
Mac Binary PS
On
Off
Auto
Sets the printer to process Macintosh binary PostScript print jobs
Notes:
• Auto is the factory default setting.
• The Off setting filters print jobs using the standard protocol.
• The On setting processes raw binary PostScript print jobs.
Network Setup
Reports Menu
Network Card menu
TCIP Menu
IPv6 Menu
Wireless menu
AppleTalk menu
SE Menu
List all the network setup menus, regardless of the active printer network
Note: Certain options are not available on selected printer models.
Wireless menu
Use the following menu items to view or configure the wireless internal print server settings.
Note: This menu is available only for network models or printers attached to print servers when an optional wireless
internal print server is installed in the printer.
Menu item Description
Mode
Infrastructure
Ad hoc
Lets you select a mode
Notes:
• Infrastructure mode makes the printer wireless network accessible
through an access point.
• Ad hoc mode configures the printer for peer-to-peer wireless
networking.
Understanding printer menus
79