Kyocera COMMAND CENTER Multifunctional Printer - Manual (Page 13)

COMMAND CENTER Pages
Operation Guide 9
Basic > Defaults > Reset
This page allows you to restart the machine in order to make all settings in the machine
valid. It is also possible to select to have all settings returned to their factory default
values.
Basic > Defaults > Device Defaults
This page allows you to change the language that is used in the display, as well as to
turn the Auto Sleep Mode On or Off.
Item Description
Restart entire
device Clicking Restart restarts this machine restarts.
After you have changed network or security settings, you
must restart this machine.
Reset entire
device to
factory default When clicking the Reset button, the machine returns to the
factory default settings. However, the document box,
address book, user information, logs, and certificates are not
deleted.
Item Description
Operation Panel
Language
You can select the language of the messages on the display
by following the procedure given below. The following
languages are available for selection in the drop down list:
English, Français, Deutsch, Italiano, Nederlands, Español,
Português, and the downloaded languages
You can optionally download messages in other languages.
Contact your dealer for information.
Some models may require restarting after configuration.
Sleep Timer Specifies the time from 1 to 240 minutes after which the
system enters the auto sleep mode.
You can turn the sleep timer On or Off as follows. The
default setting is On.
1. Click Advanced on the right hand side of the drop down
list.
2. Turn the sleep mode On or Off.
3. Click Submit.
Low Power
Timer Specifies the time from 1 to 240 minutes after which the
system enters the low power mode, where it reduces the
power consumption.
Override A4/
Letter
Specifies whether or not the A4 and Letter size paper should
be interchangeable.When turned On, for example, if the A4
paper is not in the tray, the Letter size paper will be selected
for printing.When turned Off, the Letter size paper will not be
used in place of the A4 paper, when A4 is selected for
printing but the A4 tray is empty.
Auto Error Clear Specifies whether or not to clear errors automatically when
they occur. The default setting is On.
Error Clear Timer Specifies the time between 5 and 495 seconds after which
errors are cleared automatically.