Advanced > management > snmp > snmpv3 – Kyocera COMMAND CENTER Multifunctional Printer User Manual
Page 47
COMMAND CENTER Pages
Operation Guide
43
Advanced > Management > SNMP > SNMPv3
The table below provides a summary of the items displayed on the SNMPv3 page.After you
have changed this setting, you must restart this machine. For the restarting procedure,
refer to Basic > Defaults > Reset on page 9.
sysName
The MIB-II sysName object, usually the host or domain name
of the printing system.
sysLocation
The MIB-II sysLocation object, usually the location
information of the printing system.
HP Web
Jetadmin
Compatibility
Turns HP Web Jetadmin Compatibility On or Off. After you
have changed this setting, you must restart this machine.
Authentication
Traps
Specifies whether to use authentication traps. If enabled, an
SNMP trap is generated when an attempt to read or write is
made using an incorrect community name. The trap is sent to
the configured trap address.
Trap
Community
The SNMP trap community name to be used when the
printing system generates a trap.
Trap IP Address
(IPv4)
Enter the IPv4 address that receives traps. Select On to
enable trap receiving.
Trap IP Address
(IPv6)
Enter the IPv6 address that receives traps. Select On to
enable trap receiving.
Trap IPX Address
Enter the IPX address that receives traps. Select On to
enable trap receiving.
Selected Errors
Select the events which will cause a trap to be generated
from Add Paper, Low Toner, Add Toner, Cover Open,
Paper Jam, and All Other Errors.
Item
Description
Item
Description
SNMPv3
Sets whether to use the SNMPv3 protocol. Set On to use it.
Authentication
Sets whether to authenticate the user in SNMP communication.
Hash
Selects the hash algorithm. This item is displayed when the
Authentication is On.
Privacy
Sets whether to encrypt the communicated data in SNMP
communication.
Encryption
Selects the encryption algorithm. This item is displayed when
Privacy is On.
User Name
Enter the name of the read-only user.
Password
Enter the password for the read-only user.
User Name
Enter the name of the read/write user.