KVH Industries KVHTRACVISION G4 - Manual (Page 116)

Maintenance
54-0147 109
Replacing a Fuse
Two 5x20 mm, 3.15-amp, 250-volt fast-blow fuses are mounted to
the main PCB (see Figure 5-3 on page 107). If one of these fuses
has blown or been broken, simply remove the bad fuse and
replace with a good fuse of the same rating.
5.5 Replacing the RF PCB
1. The RF PCB receives operating voltages from both
the main PCB and the IRD (via the RF cable).
Ensure that all power (including the IRD) is
turned off before proceeding.
2. Using a 5 ⁄
16
" socket wrench, remove the four nuts
and washers securing the RF PCB cover (see
Figure 5-5). Set the hardware and cover aside.
RF PCB Cover
Support Frame
RF PCB
Figure 5-5
RF PCB Mounting (Top View)