Kodak DCS500 - Manual (Page 217)

12-4
Quitting—Disconnecting from the Computer
Complete these steps when you have completed your work with the camera and the
computer.
☛
You can connect or disconnect the camera without turning the camera or the
computer off.
1 If the DCS Host Software is running, click the Done button from the Image window.
2 Disconnect the camera from the computer.
Using the Card Reader
If your computer has a card reader, you can access images by placing a PC Card
containing camera images in the reader. If you have a new card reader, install it using the
instructions accompanying the reader.
1 Remove the PC Card from your camera (page 4-3).
2 Insert the PC Card into the card reader on your computer.
☛
If your card reader is attached to a PC running NT 4.0, you may need to reboot your
system each time that you insert a PC Card into the reader.
CAUTION:
Do not disconnect the camera from the computer while the DCS Host Software is
running. Doing so may result in the loss of data from the PC Card. Be sure to exit
the software before disconnecting from the computer.