Kenwood TS-570S TS-570D - Manual (Page 16)

10
3 GETTING ACQUAINTED
REAR PANEL
q q q q q ANT 1 and ANT 2 connectors
Connect the feed lines from your antennas to these
connectors. Refer to pages 1 and 48 for details.
w w w w w AT connector
Mates with the connector on the cable supplied with the
external antenna tuner. Refer to the instruction manual
supplied with this tuner for more information.
e e e e e DC 13.8 V power input connector
Connect a 13.8 V DC power source {page 2}. Use the
supplied cable with a regulated DC power supply.
r r r r r GND post
Connect a heavy gauge wire or copper strap between
the ground post and the nearest earth ground {page 2}.
t t t t t COM connector
Mates with a 9-pin female RS-232C connector for
connecting a computer via one of its serial
communication ports {page 60}. Also used with the
Quick Data Transfer function {page 60}.
y y y y y KEY and PADDLE jacks
The PADDLE jack mates with a 6.0 mm (1/4")
3-conductor plug for connecting a keyer paddle to the
internal electronic keyer. The KEY jack mates with a
3.5 mm (1/8") 2-conductor plug for connecting an
external key for CW operation. Read “Keys and
Keyboards for CW Operation” {page 3} before
connecting to these jacks.
u u u u u ACC 2 connector
Mates with a 13-pin male DIN connector for connecting
various accessory equipment {pages 61, 62}.
i i i i i EXT SP jack
Mates with a 3.5 mm (1/8"), 2-conductor (mono) plug for
connecting an external speaker {page 3}. Connecting
an external speaker cuts off the audio automatically to
the internal speaker.
o o o o o REMOTE connector
Mates with a 7-pin male DIN connector for connecting a
linear amplifier {page 61}.
European versions only: Before connecting to the ACC 2 and
COM connectors, remove the protective covers.
ANT 2
AT
DC 13.8V
GND
EXT.SP
8Ω REMOTE
ANT 1
KEY COM PADDLE ACC 2
o
w e
r
t y u i
q