Kenwood TS-570S TS-570D - Manual (Page 51)

45
10 MEMORY FEATURES
RECALLING QUICK MEMORY
You can recall a Quick memory channel, only when
using VFO frequencies for both transmitting and
receiving.
1 Press QUICK MEMO [MR].
• The current memory channel number appears.
• If there is no data stored in any Quick memory
channel, then this step will not access Quick
memory.
2 Turn the MULTI/CH control to select a Quick
memory channel (1 to 5).
• You cannot change memory channels while
transmitting.
3 To exit, press QUICK MEMO [MR] again.
Note: Memory channels cannot be changed while using the TF-SET
function.
TEMPORARY FREQUENCY CHANGES
After recalling a Quick memory channel, you can
temporarily change the data without overwriting the
contents of the channel. You can change the frequency
even when you select OFF in Menu No. 08.
1 Press QUICK MEMO [MR].
2 Turn the MULTI/CH control to select a Quick
memory channel (1 to 5).
3 Change the frequencies and associated data.
4 To store the changed data in Quick memory, press
QUICK MEMO [M.IN].
• This action stores the new data in the current
channel and bumps the old frequency to the next
higher Quick memory channel.
5 To exit, press QUICK MEMO [MR] again.
Note: Memory channel data can also be changed while using the
TF-SET function.
QUICK MEMORY
➡ VFO TRANSFER
This function copies the contents of the memory
channel that you recalled, to the VFO.
1 Recall a Quick memory channel.
2 Press [M>VFO].
Note: Pressing [M>VFO] after temporarily changing the recalled
data copies the new data to the VFO.