Remote connections on the back panel – Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER User Manual

Page 28

Advertising
background image

(Outputs continued)

37, 38 Record Bus Outputs

The Evolution Two is equipped with one balanced record bus output with XLR

connectors and one single-ended record bus output with RCA connectors. Use

the record bus outputs to record a input signal other than the signal playing on

the main outputs. For more information, see Play and Record, on page 30.

39, 40 Main Outputs

The Evolution Two is equipped with one balanced output with XLR connectors

and one single-ended output with RCA connectors.

41 CAST Outputs

The Evolution Two is equipped with two CAST preamplifier outputs with 4-pin

bayonet connectors, for use with Krell CAST-equipped amplifiers.

Remote Connections on the Back Panel

42 RC-5 In

Each Evolution Two preamplifier chassis (1) has an RC-5 remote input. The

RC-5 remote connector is used with a third party remote control system that

provides RC-5 (IR) data with the carrier intact, via a wired connection. A stereo

tip, ring, sleeve 1/8

” mini connector is used in the following configuration: Tip =

RC-5 data, Ring = +5 V, Sleeve = GND.

43 RS-232

Each Evolution Two preamplifier chassis (1) has an RS-232 port that receives

messages from a computer-based control system, providing integrated control

of all preamplifier functions. The RS-232 input uses a 9-pin D-subminiature

connector. See the Evolution Two developer's reference, entitled RS-232 Port:

Sending Commands and Interpreting Data, for more information.

44 12 VDC In/Out (12 V Trigger)

Each Evolution Two preamplifier chassis (1) has 2 outputs that send and one

input that receives 12 VDC power on/off (12 V trigger) signals to and from

other Krell components and other devices that incorporate a 12 V trigger. This

allows you to turn other components on or off, or to and from stand-by,

through the remote control. When the Evolution Two is switched to operational

mode and is connected to other components through the 12 V trigger, it sends

a signal that will switch other components, allowing whole systems or parts of

24

(SECTION FOUR: Anatomy of an Evolution Two continued)

Advertising