Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER - Manual (Page 30)

26
SECTION
FIVE
Connecting the Evolution Two
to Your System
This section describes Evolution Two Monaural Preamplifier connections and intro-
duces the CAN Link remote control option.
Input and Output Connections
Krell recommends using its proprietary Krell CAST system for unparalleled sonic
performance for connections between the Evolution Two preamplifier and other
CAST-equipped components. Krell CAST uses flexible interconnecting cables that
can be drawn through tight spaces and concealed.
The Evolution Two also offers balanced operation. The circuitry and connections
associated with balanced operation not only can minimize sonic loss but also are
immune to induced noise, especially for installations using long cables.
XLR Pin Configuration
Pin 1 Ground
Pin 2 Non-inverting (0 O )
Pin 3 Inverting (180 O )
Inputs and outputs are located on the Evolution Two back panels. Maintain the
correct left/right orientation, when hooking up your system.
Left/Right Channel Orientation
Evolution Two preamplifiers are assembled as left or right channels. Preamplifier
RCA connectors (31, 36, 38, 40) are color coded. Left preamplifier channels are
assembled with white RCA connectors, and right preamplifier channels are
assembled with red RCA connectors.
Connection Steps
Position each power supply and preamplifier chassis where you intend to use the
connected channels. Do do not move the connected chassis after they are
assembled.