Krell Industries EVOLUTION TWO MONAURAL PREAMPLIFIER - Manual (Page 34)

30
To Turn Off Your System
1. Place the amplifiers in the stand-by mode.
2. Press the power button on the preamplifier chassis front panel or the pwr key
(3) on the remote control to switch the Evolution Two to the stand-by mode.
3. Turn off the amplifiers using the back panel power switch or by disconnecting
them from AC power.
4. Turn off the Evolution Two by unplugging the AC power cord from AC power.
Play and Record
The Evolution Two allows you to listen to one source through the main output (39
or 44), while recording a different source through the record bus output (37 or 38).
A main bus tape output (35, 36) is also available and allows for the connection of a
second recording device.
1. Press the power button (3) on the preamplifier chassis front panel (1) to switch
the Evolution Two from stand-by to the operational mode.
2. Press the input selection button on the preamplifier chassis front panel or the
input selection keys (8, 9, 10, or 11) on the remote control to select the source
that you want to listen to through the main outputs.
3. Begin playing the source. Use the level control knob on preamplifier chassis
front panel or the level keys (16) on the remote control to adjust the volume to
the desired listening level.
4. Press the record button on the preamplifier chassis front panel or the record
key (13) on the remote control. The red record LED illuminates on the preampli-
fier chassis front panel.
5. Press the input selection button or keys to select the source that you want to
record through the record bus output . This source can be different than the
source selected for the main bus outputs, in Step 2.
6. Press the record button or the main key (21) on the remote control, to return to
the main bus output.
(SECTION SIX: Evolution Two Operation continued)