Kyocera Jet KX18 - Manual (Page 23)

PAGE 15 | ROAMING | MAKING AND ANSWERING CALLS
Timing your calls
You can set your phone to beep 10 seconds
before each minute passes when you are
on a call.
• Select Menu → Settings → Sounds →
Minute Alert → Enabled.
Roaming
Setting an alert for roaming
You may use this setting if you want the phone
to alert you when you roam outside of your
home service area.
1. Select Menu → Settings → Network →
Roam/Svc Alert.
2. Select an option and press the
Amp’d/OK key
.
• When no svc alerts you with three tones
decreasing in pitch when service is lost
and three tones increasing in pitch when
service is acquired again.
• On roam change alerts you with two
decreasing tones when roaming service
is acquired and three increasing tones
when home area service is
acquired again.
• On any change alerts you with three
increasing tones if there is a change in
roaming service or three decreasing
tones if the phone loses service.
Setting the roam ringer
You can set a ringer to indicate when an
incoming call will be subject to roaming charges.
• Select Menu → Settings → Sounds →
Roam Ringer → Enabled.
Setting Call Guard
You can set the phone to warn you before you
answer or place a call while roaming.
• Select Menu → Settings →
Convenience → Call Guard →
Call Prompt.
• The phone now emits a distinctive roam
ring to indicate when you are roaming
during calls.
• To accept or place a call while roaming,
you must press the “1” key
.
Note: Call Prompt is disabled when the phone
is in Emergency Mode.
Using your phone in an airplane
While in an airplane, it is normally required that
you turn off your mobile phone because it emits
RF signals that interfere with air traffic control.
In Airplane mode, however, your phone will not
emit RF signals. You cannot make or receive
calls, send text messages, or use the Web, but
you can play games, use the Scheduler, set the
clock, and make emergency calls to designated
emergency numbers.
Note: Please check with uniformed personnel
before operating your phone in
Airplane mode.
Setting Airplane mode
1. Select Menu → Settings →
Convenience → Airplane Mode.
2. Press the Amp’d/OK key to select OK
after reading the message.
3. Select Disabled or Enabled.