Kenwood DIGITAL MEDIA RECEIVER KIV-700 - Manual (Page 51)

English |
51
Registering Bluetooth Device
To make your Bluetooth device (cell-phone) usable
with this unit, you need to register it (pairing). You
can register up to 5 Bluetooth devices to this unit.
Registering from this unit
1
Enter Bluetooth mode
Press the [TI] button for at least 1 second.
2
Enter Bluetooth device registration mode
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “BT Settings”
> “Detailed Setup” >
“Device Registration”.
Search for the Bluetooth device.
When search is completed, “Finished” is displayed.
3
Select a Bluetooth device
Turn the [Volume] knob and press it when the
desired item is displayed.
4
“Pairing” is displayed (KCA-BT300 only)
If “Pairing Success” is displayed, proceed to step 7.
If “PIN Code NG” is displayed, proceed to steps 5.
5
Input the PIN code
1. Turn the [Volume] knob and press it when
the desired item is displayed.
Select the digit.
2. Turn the [Volume] knob to select the
numbers, and then press the [Volume] knob.
6
Transmit the PIN code
Press the [Volume] knob for at least 1 second.
If “Pairing Success” is displayed, registration is
completed.
✍ If the error message appears even though the
PIN code is correct, try
<Registering Special
Bluetooth device> .
7
Return to the device list
Press the [Volume] knob.
8
Exit BT Setting mode
Press the [MENU] button for at least 1 second.
⁄
• This unit allows up to eight digits to be input for a PIN
code. If a PIN code cannot be input from this unit, it can
be input from the Bluetooth device.
• If there are 5 or more Bluetooth devices registered, you
cannot register a new Bluetooth device.
Registering Special Bluetooth device
Allow registration of a special device that cannot be
registered normally (pairing).
1. Select Special device registration mode
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “BT Settings” > “Detailed Setup” > “Special
Device Select”.
A list is displayed.
2. Select a device name
Turn the [Volume] knob and push the center
when the desired device name is displayed.
If “Completed” is displayed, registration is
completed.
3. Go through the procedure step 3 of
<Registering from this unit> and complete
the registration (pairing).
Cancelling Special device registration mode
Press the [MENU] button for at least 1 second.
⁄
• If the device name is not in the list, select “Other Phones”.