KORG OASYS musical instruments - Manual (Page 190)

Loading & saving data, and creating CDs
182
Note: Resetting the REALTIME KNOBS of MODE
R.TIME KNOBS/KARMA will set them to the center
position.
Note: MODE TONE ADJUST will be reset as follows,
depending on the parameter that is assigned.
For a program, absolute-type parameters will be reset
to the specified value, and relative-type parameters
will be reset to the center.
For a combination, they will be reset to the written
values. For a sequencer song, they will be reset to the
state in which they were immediately after you entered
the mode, selected the song, or executed Copy From
Combi, etc.
Shortcuts
ENTER switch + numeric keys 0–9
• Accesses the page menu commands in each page
(up to ten items)
ENTER switch + REC/WRITE switch
• Accesses the Auto Song Setup function. In Program
or Combination mode you can press this
combination of keys to automatically assign the
settings of the program or combination to a song in
Sequencer mode, and then enter record-ready
mode.
ENTER switch + keyboard
• Inputs note number values or velocity values
• Selects “KEY” in Global P5: Drum Kit, Sequencer
P5: Pattern/RPPR, RPPR Setup page
• Selects base key and index in Sampling mode
ENTER switch + LOCATE switch
• In Sequencer mode, sets the current location as the
“Location” (equivalent to the “Set Location” page
menu command)
KARMA MODULE CONTROL switch + CONTROL
ASSIGN R.TIME KNOBS/KARMA switch (LED ON)
In Combination or Sequencer mode, set Module
Control to Master. (The same operation as setting
Module Control=M in P0: Control Surface–
RT/KARMA)
CONTROL ASSIGN TONE ADJUST switch
(LED ON) + SWITCH 1…16 switches
In Combination or Sequencer mode, these select the
timbre or MIDI track that you will control. (The same
operation as selecting a Timbre/Track in P0: Control
Surface)
EXIT switch
This button makes it easy to return to the main page of
the current mode:
• Press it once to go to the previously-selected tab on
the main P0 page.
• Press it again to go to the first tab on the main P0
page.
• Press it a third time to select the main parameter on
the P0 page, such as the Program name in Program
mode.
Wherever you are in Program, Combi, or Sequencer
modes, pressing EXIT three times (or fewer) will take
you back to Program/Combination/Song Select,
where you can immediately use the numeric keys or
/ switches to select a Program, Combination, or
Song.
EXIT switch (in dialog boxes)
When a dialog box is displayed, this has the same
function as the Cancel, Done, or Exit button.