KORG OASYS musical instruments - Manual (Page 42)

Introduction to OASYS
34
Note: As with the meter as a whole, the number shown
in FREE FOR VOICES is only an approximation. For
example, if FREE FOR VOICES is showing 98, the
maximum polyphony for the HD-1 may not be exactly
172 x 0.98 (approximately 168). The maximum polyphony may also depend on various
other parameters; for more information, see “A note
about polyphony” on page 32 of the Parameter Guide.
Basic operations
After you’ve turned on the OASYS, here’s how to
perform basic operations such as selecting modes and
pages.
1. Selecting modes
In order to use a particular function on the OASYS,
you must first select the appropriate mode.
Press one of the front panel mode buttons (COMBI,
PROGRAM, SEQ, SAMPLING, GLOBAL, or DISK)
to enter the corresponding mode.
2. Selecting pages
Each mode has a large number of parameters, which
are grouped into pages. These are further subdivided
by tabs into up to nine tab pages.
1. Make sure that the desired mode is selected.
To select a mode, press the appropriate mode key
(COMBI switch – DISK switch).
Here we will use Program mode as an example for our
explanation. Press the PROGRAM switch.
2. Press a tab in the lower line (page group tabs).
As an example here, press the Basic/Vector tab. The
current page indication in the upper left of the LCD
screen will indicate “PROGRAM P1: Basic/Vector,”
and the page group will change.
When you press the EXIT switch, you will return to P0
from any page.
Effect EXi Fixed Free for Voices
Resource Meter
COMBI switch: Combination mode
PROGRAM switch: Program mode
SEQ switch:
Sequencer mode
SAMPLING switch: Sampling mode
GLOBAL switch:
Global mode
DISK switch: Disk mode
Page
group Tab
Page tab