KORG D8 - Manual (Page 54)

55
Chapter 3 Reference
14. EDIT METRONOME
Metronome volume setting
If the metronome is on (refer to METRONOME), the
metronome will sound when you enter this page. You
can adjust the volume while listening to the metro-
nome.
P1-1 Metronome volume setting...................... [001...100]
Adjusts the volume of the metronome.
The value can be changed either from this page or
from EDIT TEMPO P2. To turn the metronome on/off
while you are in this page, press the [EDIT] key and
then press the [METRONOME] key to switch it on/off.
Metronome mode setting
P2-1 Metronome mode setting................. [P+R, Rec, Off]
Specifies when the metronome will be sounded when
it is turned on (refer to METRONOME).
P+R (Play+Recording): The metronome will sound
during playback and during recording.
Rec
(Recording): The metronome will sound during
recording.
Off
: The metronome will not sound during either
playback or recording, regardless of the Metronome
On/Off setting.
15. IN/LOC1, OUT/LOC2,
TO/LOC3
You can store any desired location in the song to the
[IN/LOC1], [OUT/LOC2] and [TO/LOC3] keys,
allowing you to move to the specified location (“locate
point”) by pressing the appropriate key.
The times that have been stored can also be used for
Auto Play/Auto Repeat Playback, as the in/out points
for Auto Punch Recording, and as edit points for track
editing.
✧ To store the current time to a key, press [STORE] and
then press the desired [LOC (/IN,OUT,TO)] key.
IN/LOC1 ..................................................................
The time location stored to the [IN/LOC1] key will act
as follows when the corresponding function is
selected.
•
Move to locate point 1
•
Punch-in time for Auto Punch Recording
•
Playback begin time for Auto Play/Auto Repeat Play-
back
•
When performing track editing,
starting time for the copy source in Copy Track
starting time for the inserted blank in Blank Insert
Track
starting time for the erased area in Erase Track
starting time for the deleted area in Delete Track
starting time for the swap source/destination in Swap
Track
OUT/LOC2 ...............................................................
The time location stored to the [OUT/LOC2] key will
act as follows when the corresponding function is
selected.
•
Move to locate point 2
•
Punch-out time for Auto Punch Recording
•
Playback end time for Auto Play/Auto Repeat Play-
back
•
When performing track editing,
ending time for the copy source in Copy Track
ending time for the inserted blank in Blank Insert
Track
ending time for the erased area in Erase Track
ending time for the deleted area in Delete Track
ending time for the swap source/destination in Swap
Track
TO/LOC3..................................................................
The time location stored to the [TO/LOC3] key will act
as follows for when the corresponding function is
selected.
•
Move to locate point 3
•
When performing track editing,
location to which data will be copied by Copy Track
P1
1
MetVol:050
P2
1
MetMod:P+R