KORG CX-3 - Manual (Page 25)

Parameters
21
Wheel Brk Ctrl (Controller for Wheel Brake)
[Off, Pedal 1/(Pdl 1)*, Pedal 2/(Pdl 2)*]
Pedal 1: A pedal switch etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 1 jack can be used to
turn the Global mode Group 7 “Wheel Brake” param-
eter on/off.
Pedal 2:
A pedal switch etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 2 jack can be used to
perform the above function.
Off:
No function.
Rtry Fast Ctrl (Controller for Rotary Fast)
[Off, Pedal 1/(Pdl 1)*, Pedal 2/(Pdl 2)*]
Pedal 1: A pedal switch etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 1 jack can be used to
turn the ROTARY section [FAST] key on/off.
Pedal 2:
A pedal switch etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 2 jack can be used to
perform the above function.
Off:
No function.
Rtry Stop Ctrl (Controller for Rotary Stop)
[Off, Pedal 1/(Pdl 1)*, Pedal 2/(Pdl 2)*]
Pedal 1: A pedal switch etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 1 jack can be used to
turn the ROTARY section [STOP] key on/off.
Pedal 2:
A pedal switch etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 2 jack can be used to
perform the above function.
Off:
No function.
Amp Gain Ctrl (Controller for AMP Gain)
[Off, Pedal 1/(Pdl 1)*, Pedal 2/(Pdl 2)*]
Pedal 1: An expression pedal etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 1 jack can be used to
control the Normal Edit mode or EX Edit mode Group
4 “Amp Gain” parameter.
Pedal 2:
An expression pedal etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 2 jack can be used to
perform the above function.
Off:
No function.
Amp Gain Ctrl Min (AMP Gain Control Range
Minimum)
[0...99]
This sets the minimum value of the Normal Edit mode
or EX Edit mode Group 4 “Amp Gain” parameter.
This will be the gain when an expression pedal etc.
specified by the “Amp Gain Ctrl” parameter is set to
its minimum position.
Amp Gain Ctrl Max (AMP Gain Control Range
Maximum)
[0...99]
This sets the maximum value of the Normal Edit
mode or EX Edit mode Group 4 “Amp Gain” param-
eter.
This will be the gain when an expression pedal etc.
specified by the “Amp Gain Ctrl” parameter is set to
its maximum position.
Rev Mix Ctrl (Controller Select for Reverb Mix)
[Off, Pedal 1/(Pdl 1)*, Pedal 2/(Pdl 2)*]
Pedal 1: An expression pedal etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 1 jack can be used to
control the Normal Edit mode or EX Edit mode Group
5 “Reverb Mix Level” parameter.
Pedal 2:
An expression pedal etc. connected to the rear
panel ASSIGNABLE PEDAL/SW 2 jack can be used to
perform the above function.
Off:
No function.
Rev Mix Ctrl Min (Reverb Mix Control Range
Minimum)
[0...99]
This sets the minimum value of the Normal Edit mode
or EX Edit mode Group 5 “Reverb Mix Level” param-
eter.
This will be the reverb mix level when an expression
pedal etc. specified by the “Reverb Mix Ctrl” param-
eter is set to its minimum position.
Rev Mix Ctrl Max (Reverb Mix Control Range
Maximum)
[0...99]
This sets the maximum value of the Normal Edit
mode or EX Edit mode Group 5 “Reverb Mix Level”
parameter.
This will be the reverb mix level when an expression
pedal etc. specified by the “Reverb Mix Ctrl” param-
eter is set to its maximum position.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Group 8
Rename
Here you can modify the name. You can use up to
twelve characters.
Use the [
√
][®] keys to select the character that you
wish to change, and use the [–]/[+] keys to select the
character.
The following characters can be used.
* (Pdl 1), (Pdl 2): These indicate that Pedal 1 or Pedal 2 are selected for the Global mode Group 1 “Prog Up Ctrl” or “Prog Down Ctrl” parameters. With these settings, the settings of Global
mode are used, and the settings you made here will be ignored. However if you select another value in Global mode, the display here will change from (Pdl 1) to Pedal 1 or from (Pdl 2) to
Pedal 2, and you will be able to operate the corresponding function from the pedal switch.