KORG D3200 - Manual (Page 171)

161
Effect
Algorithm list
Program list
Stereo type
Algorithm
Monaural type
Algorithm
Category: Dynamics&Filter
Dynamics/Filter-type effects
Reso HiCut (Resonance High Cut) 53Hz...20.0kHz, THRU
Sets the resonance damping amount in the high range
Type Blue, U-VB
Selects the type of phaser
Waveform (LFO Waveform) Triangle, Sine
Selects LFO Waveform
40: Mono Tremolo
*Speed (LFO Speed) 0.02...20.00Hz
Sets the LFO speed
*Depth 0...100
Sets the depth of LFO modulation
Waveform (LFO Waveform)
Triangle, Sine, Square, Saw up, Saw down
Selects LFO Waveform
Dry:Wet Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
LFO Shape –100...+100%
Determines how much the LFO waveform is changed
41: Mn.Pitch Shifter
(Mono Pitch Shifter)
PitchShift –24...+24/2tone
Sets the pitch shift amount in steps of a semitone
Fine –100...+100cent
Sets the pitch shift amount in steps of one cent
Lo/Hi Cut (Low/High Cut) Lo:-50%..., Flat, ...Hi:-50%
Sets the damping amount in the low/high range
Dry:Wet Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
Feedback –100...+100%
Sets the feedback amount
In Level (Input Level) 0...100%
Sets the input level to the effect
42: Mono Compressor
Threshold –30.0...0.0dB
Sets the level at which compression begins to apply
Ratio 1.00:1...20.0:1
Sets the compression ration of the signal
Attack 0...1.00sec
Sets the attack time
Release 0...10.0sec
Sets the release time
Response Slow, Medium, Fast
Selects the response speed
Tube Sat (Tube Saturation) 0...100
Sets the depth of vacuum tube distortion
Out Gain (Output Gain) –24.0...+24.0dB
Adjusts the output level gain
43: Mono Expander
Threshold –48.0...0.0dB
Sets the level at which compression begins to apply
Ratio 1.00:1...20.0:1
Sets the compression ration of the signal
Attack 0...1.00sec
Sets the attack time
Release 0...10.0sec
Sets the release time
Response Slow, Medium, Fast
Selects the response speed
Out Gain (Output Gain) –24.0...+24.0dB
Adjusts the output level gain
44: Mono Limiter
Threshold –48.0...0.0dB
Sets the level at which compression begins to apply
Attack 0...1.00sec
Sets the attack time
Release 0...10.0sec
Sets the release time
Out Gain (Output Gain) –24.0...+24.0dB
Adjusts the output level gain
Response Slow, Medium, Fast
Selects the response speed
Tube Sat (Tube Saturation) 0...100
Sets the depth of vacuum tube distortion
45: Mono Gate
Threshold –48.0...0.0dB
Adjusts the level at which compression
Attack 0...1.00sec
Sets the attack time
Release 0...10.0sec
Sets the release time
Range –inf, –48...0.0dB
Compression level
Response Slow, Medium, Fast
Selects the response speed
PreDelay (Pre Delay Time) 0...200ms
Sets the delay time
Out Gain (Output Gain) –24.0...+24.0dB
Adjusts the output level gain
46: Mono Filter
Fc Bottom (Control Fc Bottom) 53Hz...20.0kHz
Sets the lower limit of the frequency to be controlled
Fc Top (Control Fc Top) 53Hz...20.0kHz
Sets the upper limit of the frequency to be controlled
Resonance 0...100%
Sets the resonance amount
Trim 0...100%
Adjusts the filter level
FilterType HPF, BPF, LPF
Selects the filter type
Control (Control Source) Envelope, LFO
Switches the control source
Polarity [+]Plus, [–]Minus
Inverts the control
Monaural type
Algorithm