KORG D3200 - Manual (Page 173)

163
Effect
Algorithm list
Program list
Stereo type
Algorithm
Monaural type
Algorithm
This effect simulates a wide variety of microphones. You can
also adjust the preamp.
Category: Multi
Multi Effect
This is a multi-chain effect for guitar.
Chain: [Wah]-[Comp]-[Mod]-[Amp]-[Dly]
Parameters for the effects in the chain
Wah (Wah Wah)
Comp (Compressor)
Mod (Modulation)
Amp (AmpCabModeling)
This effect models a guitar amp cabinet.
Dly (Long Delay)
51: Mic Simulator
MicType (Microphone Type)
Vntg.Dy, Multi.Cn, Prcs.Cn, Whale, Vo.Cn, Vo.Tube, BDr.Dy
Selects the type of mic
MicPosition (Microphone Position) Close, On, Off, Far
Selects the position of the mic
PreAmp G (Pre Amp Gain) –24.0...+24.0dB
Sets the gain of the tube preamp
TubeSat (Tube Saturation) 0...100%
Sets the amount of tube saturation
TubeBias 0...100
Vacuum tube bias adjustment amount
LowCut THRU, 21Hz...8.00kHz
Sets the damping amount in the low range
HiCut (High Cut) 53Hz...20.0kHz, THRU
Sets the damping amount in the high range
OutLevel (Output Level) –48.0...00dB
Sets the output level
52: GuitarMulti
Control (Control Source) Envelope, Manual
Switches the control source
Wah.Type Y-CRY, RM-A, RM-B, J-CRY, VOX, M-VOX
Selects the wah type
Env.Resp (Envelope Response) Slow, Medium, Fast
Selects the response speed of envelope control
Env.Sens (Envelope Sensitivity) 0...100%
Sets the sensitivity of envelope control
*Manual (Manual Control) 0...100
Sets the control position manually
DirectMix (Direct Mix Level) 0...100%
Adjusts the mix level of the direct sound
Wah Level 0...100
Sets the wah level
Threshold –48.0...0.0dB
Sets the level at which compression begins to apply
Attack 0...1.00sec
Sets the attack time
OutGain (Output Gain) –24.0...+24.0dB
Adjusts the output level gain
ModType (Modulation Type) Chorus, Flanger, Tremolo
Selects the modulation type
Speed (LFO Speed) 0.02...20.00Hz
Sets the LFO speed
Shape (LFO Shape) –100...+100%
Determines how much the LFO waveform is changed
Depth 0...100
Sets the depth of LFO modulation
AmpType (AmpType)
AC15, AC30, AC30TB, BLK2x12, TWD1x12,
TWD4x10, BTQ CL, BTQ OD, UKBUES, UK’70S,
UK’80S, UK’90S, UK MDN, US MDN, RECTO, US HI-G
Selects the type of amplifier
DRIVE (Drive Level) 1...100
Sets the amount of distortion
VOLUME (Volume Level) 1...100
Sets the volume level
CabType (CabinetType)
1x12TWD, 2x10BLK, 2x12BLK, 1x12VOX, 2x12VOX,
4x10TWD, , AD412, UK-H30, UK-T75, US-V30, OFF
Selects the type of cabinet
BASS 0...100
Sets the low-frequency level
MIDDLE 0...100
Sets the mid-frequency level
TREBLE 0...100
Sets the high-frequency level
PRESENCE 0...100
Sets the level of the high region
NR.Thrsh (NoiseReduction Threshold) 0...100
Level at which noise reduction begins to apply
Time (Delay Time) 0...10.365sec
Sets the delay time
Feedback –100...+100%
Sets the feedback amount
In Level (Input Level) 0...100%
Sets the input level to the effect
Dry:Wet Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
LoDamp (Low Damp) THRU, 21Hz...8.00kHz
Sets the damping amount in the low range
HiDamp (High Damp) 53Hz...20.0kHz, THRU
Sets the damping amount in the high range
Monaural type
Algorithm