Normal playback, Preparing for playback, Listening to a source component – Kenwood KRF-X9050D User Manual
Page 23
23
Preparing for playback
Some preparatory steps are needed before starting playback.
Selecting the input mode
If you have selected a component connected to the
CD/DVD, DVD/6ch,
VIDEO2,
or
VIDEO3
jacks, make sure that the input mode setting is
correct for the type of audio signal to be used.
8
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
1
Use the INPUT SELECTOR knob to select “MD/TAPE”.
2
Hold down the AUTO key for more than 2 seconds.
• The source indication changes to “
MD
”.
• To return to the original indication, repeat procedure
2.
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to
be used.
A ON
:
Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON
:
Sound from the speakers connected to the SPEAKERS B
terminals on the rear panel. No sound will be heard from
subwoofer.
A+B ON :
Sound from both the speakers connected to the SPEAKERS
A and B terminals on the rear panel.
A+B OFF :
No sound from the speakers. Use this setting when listening
with headphones for stereo sound in all playback modes.
• Selecting “6ch INPT” by pressing the INPUT MODE key, whereby
“DVD/6ch” is the input source will cause SPEAKERS A to be selected
automatically.
• When you use the PRE OUT jacks, set only SPEAKERS A to ON
mode.
Turning on the receiver
1
Turn on the power to the related components.
2
Turn on the power to this receiver by pressing POWER and
ON/STANDBY( ) keys.
Normal playback
Listening to a source component
1
Use the INPUT SELECTOR knob or keys to select the
source you want to listen to.
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or RECEIVER VOLUME
keys to adjust the volume.
1
“PHONO”
2
“TUNER”
3
“CD/DVD”
4
“TAPE” or “MD”
5
“VIDEO1”
6
“VIDEO2”
7
“VIDEO3”
8
“DVD/6ch”
9
“AV AUX”
LFE
C
S
RS
LS
TI.VOL
CLIP
MUTE
RDS
EON
PTY
TP
TA
NEWS
L
SP
A
R
SW
B
The indicator for the speakers
you want to use should be lit.
AUTO
INPUT MODE
INPUT SELECTOR
SPEAKERS A/B
POWER
ON/STANDBY( )
INPUT SELECTOR
VOLUME CONTROL
RC-R0714
RC-R0715
INPUT
SELECTOR
RECEIVER
VOLUME
Operations